FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
5925 Discussions

Sometimes can't program 10M80 Development Board

Altera_Forum
Honored Contributor II
‎01-11-2017 10:09 AM
1,088 Views

I have this strange error when I try to program the board. At work it works fine, but when I'm working from home I get a "209012 Operation failed" error. It's happening today and last week, but yesterday at the office there was no problem. I have tried unplugging my laptop so there is only one connection to 230V (the board's wall wart), and I am using the same USB port and cable. The progress bar randomly reaches 7%, 8%, 9%, 10%, and once 20%. I really can't figure out what is going on. 

 

https://s27.postimg.org/c98b90g0v/programmer_error.png (https://postimg.org/image/c98b90g0v/)
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎01-12-2017 06:17 AM
343 Views

Now at work and tried again with the exact same .cdf files, and no problems programming. Same setup. Laptop on table without power connection, same two USB cables in same two USB ports, to same dev board USB micro ports. Same dev board power supply. 

 

Could the dev board be very sensitive to temperature or humidity differences? The office has A/C, but the home office doesn't. Maybe if it has a poor solder joint or something?
0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.