Simulation using Quartus generated ibis models

Intel® Quartus® Prime Software

Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)

Simulation using Quartus generated ibis models

1,055 Views

Hi I'm using Quartus to generate ibis models for my circuit simulation in Altium DXP 2004. Using the simulation analysis to impedance match the signals and I find that 50 ohm series resistances will reduce the noise. I go and enable the 50 ohm output series resistances in Quartus on the troubled signal outputs and re-simulate. However, I get the same results!

The 50 ohm series output resistance I have enabled seems to have made no difference to the simulation results.

I've run through all the appropriate steps in the simulation, and spent many hours fixing/adjusting ibis models, double checked that specific pins are being assigned the correct models (input, output) etc...

Has anyone done this before? Any ideas why there is no change in my results? Suggestions of things I should check?

Thanks!!

Link Copied

0 Replies

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.