- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HI !!:) Itry program FLEX10K.
I have strange problem: i open programmer in Qartus 7 but it's dont recognize my Jtag cabel/ it's write "no hardware"/ I tried program FLEX10K from MAXPLUS programer ant it's work/ plese help to solve this problem!!!!Link Copied
4 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Which cable?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
cabel
ByteBlasterII- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
"no hardware" means, that the ByteBlaster II hasn't been selected (respectively not yet installed) in programmer hardware setup. If ByteBlaster is selected but not recognized, the message is "hardware not connected".
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
wow I so donkey!!! i have done it 20 times today/ i opened Hadware setup->
add hadware->choose Byteblaster. but only one i haven't done - to choose in curently celected hadware --byteblaster/ thanks for you !!! I'm going to work ill to morning
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page