- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
how to overcome the warning while accessing the SSRAM.. This is the warning we are getting when we synthesize the code . Warinig : Following 2 pins must use external clamping diodes info: pin dq[0] uses IO standard 2.5 v at H3. info: pin dq[1] uses IO standard 2.5 v at D1. I am getting the constant high (1) output for these pin outputs, when I am simulating the code. Even I observed the outputs in Signal Tap II analyser . But I already changed the device settings to choose these pins as user IO even then the same probelm continues.. Please suggest me waht I need to do to overcome the error .. Hoping an early reply.. Thanks Srinath.Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Have you tried enabling clamp diode option on these two pins in your IO settings option of Assignment editor.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page