Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
16612 Discussions

How can I run modelsim other than Active-HDL in DSP Builder?

Altera_Forum
Honored Contributor II
‎09-04-2009 06:53 AM
1,240 Views

Hello, 

 

When I use DSPbuilder, I add the model "Testbench" and then run modelsim. It always pop up Active-HDL which installed in my computer. Of course, modelsim is also installed in my computer. How can I configurate the DSPBuilder to run modelsim other than Active-HDL? 

 

Than you!
0 Kudos

Link Copied

2 Replies
Altera_Forum
Honored Contributor II
‎09-04-2009 03:13 PM
395 Views

DSP Builder is probably calling vsim based on whatever is on your PATH environment variable. try opening a command prompt and typing vsim. if Active-HDL pops up you'll need to edit Active-HDL out of your PATH environment variable (Start => Control Panel => System => Advanced => Environment Variables). check the User and System variables for the Aldec path and remove it. make sure the ModelSim path is present.

0 Kudos
Copy link
Altera_Forum
Honored Contributor II
‎09-07-2009 09:07 AM
395 Views

hello, thepancake you are right. Thank you!

0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.