FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
5892 Discussions

MAX 10 Development Kit RGB Led

Altera_Forum
Honored Contributor II
1,001 Views

Hi, 

I am new to altera FPGAs and purchased recently the 

MAX 10 FPGA Development Kit, embedded with 10M50DAF484C6GES fpga. 

 

I am using the dev-board rev C, and looking at the schematics of the dev-board 

I see the RGB led is connected to the FPGA at pins r->E2, g->E3, b->E4. 

However, I am trying to drive the rgb led on/off and it doesn't work (no voltage change on nmos gates). 

In addition at pin planner screen, pin E2 is connected to ground internally inside the FPGA, which means i can't assign any signal to this pin. 

 

Is the RGB led available to use with my dev-board? 

 

 

EDIT: 

I didn't notice the RGB led is not connected to the FPGA on board but to the embedded on board blaster. 

 

 

Thanks
0 Kudos
0 Replies
Reply