- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Still very much a beginner here.
I am using a de2 board as my development board. I have have written a program which uses various Altsyncram for storing data. When i run it on the simulator all seams fine and i can see the data values stored, but when i run in on the board it look like it does not store any data. I have set up both hex and mif files. There is no cpu or anything flash just ins out and a bit of memory to store data. Do you have to do anything to get the de2 to set up memory so the program will use this or am i missing somethig basic !!! janLink Copied
0 Replies
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page