- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have the design where i have FPGA logic interfacing with Nios-II. I used Quartus Prime 16.1 Standard Edition. I used Cyclone-IV Device EP4CE55. I want to put the FPGA configuration and Nios-II application software into the EPCS without using EPCS Controller in Qsys. Is there any method to do? Thanks in advance Regards, Nandish Jasani.Link Copied
6 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Any reason not to use the EPCS Controller?- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Thanks for your reply. I used Two Nios-II in Qsys, one Nios already interfaced with EPCS Controller, but another is not. But both Nios-II systems are independent configure in a Qsys. Nandish Jasani.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
How many EPCS devices are you using? Do you plan to boot both Nios from the same EPCS memory? You may refer to https://www.altera.com/content/dam/altera-www/global/en_us/pdfs/literature/tt/tt_nios2_multiprocessor_tutorial.pdf "Boot Addresses" section for details.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Acutally both nios configured in Autonomous method, both are isolated system and i have only one EPCS Device in my board. EPCS memory used only for one nios. For another i want to use FPGA Memory. Nandish Jasani.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Sorry I am getting confused. You mean one Nios is using EPCS while another is using On-Chip Memory? Can you be more precise in describing your problem?- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I used Two Nios-II in Qsys.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page