- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear expert.
I use SOPC to bulid a triple_speed_ethernet_design(Q9.1_example_design) + VGA. I add VGA IP in sopc and VGA's master connected to ddr2_bot's slave. Then there are errors about "Error : ddr2_bot.s1: Appears at more than one address(0x00000000,0x10000000) Why this happen?Link Copied
4 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What is the other thing connected to ddr2_bot.s1? The one at the bottom?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You need to fix the addresses of ccb_dma_to_ddr2 and pb_dma_to_ddr2 to 0x00000000. Currently the ccb_dma_to_ddr2 bridge offsets the addresses by 0x100000000 which means that the ddr2 would be seen at two different addresses depending on the master that would access it.
I don't think that you need the pb_dma_to_ddr2 bridge. Why is your ddr2 clock set to clkin_50 instead of ddr2_lo_latency_128m_sysclk?
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page