Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20704 Discussions

88e1111 phy

Altera_Forum
Honored Contributor II
‎05-24-2017 06:14 AM
1,566 Views

I have designed Cyclone V FPGA based board. 

 

When i try to program, initial configuration is not working in Ethernet PHY. 

 

Can't see any LED glowing in Ethernet PHY. 

 

Hereby I have attached Ethernet PHY schematic. 

 

Please verify and guide me to clear this issue.
Preview file
129 KB
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎05-24-2017 09:42 AM
688 Views

Using a Marvel chip on a custom board is really really not recommended because it is impossible to get the datasheet from Marvel... But now that the damage is done, I'd look for the usual culprits. Begin by testing the power rails, then the reset and clock signals with a scope, and then attempt MDIO communication with the PHY chip and see if you get any response.

0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.