Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
16609 Discussions

error in the address width of CFI in sopc builder

Altera_Forum
Honored Contributor II
‎05-10-2010 12:04 PM
954 Views

Hi,everyone,please forgive my poor English! 

I use the Quartus II 9.1 in windows xp.In the sopc builder,I set the address width(bits) of flash memory interface as 22 .Then ,in the .bdf file of the project the address width is 23 (address_to_the_cfi_flash[22..0]). 

I don't know what's wrong,how can I do this right?
0 Kudos

Link Copied

2 Replies
Altera_Forum
Honored Contributor II
‎05-10-2010 01:39 PM
278 Views

So you are using 16bit Flash, right? 

The address from sopc builder is BYTE ADDRESS, and the address of you flash chip is WORD ADDRESS. 

Simply throw the A0 from your nios module away, connect them like this: 

Your Nios Module Flash Chip 

A1 A0 

A2 A1 

... 

... 

A22 A21
0 Kudos
Copy link
Altera_Forum
Honored Contributor II
‎05-10-2010 02:31 PM
278 Views

Thank you very much!!!

0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.