Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20704 Discussions

Cyclone III active parallel (AP) configuration supported flash

Altera_Forum
Honored Contributor II
‎05-12-2010 11:02 AM
1,030 Views

In the thread "using numonyx p33 tsop for ciii ap config"(i am unable to post the link) proposed support for the new 65nm Numonyx flash memories was indicated to be supported by november 2009. 

 

Does anyone know what the current situation is? Which currently available flash is supported by the cyclone III for AP configuration? 

 

The old ones are now obsolete 

 

Thanks 

 

Jonathan
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎05-14-2010 10:35 PM
306 Views

I have the same problem. I have an evaluation kit design in production that sticks close to Altera's Cyclone III Starter Board design. When Numonyx PC28F256P30B85 was obsolete its replacement was PC28F256P30BFA. Numonyx was recently acquired by Micron, and I don't know what the equivalent Micron replacement part is. 

 

Mark
0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.