Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20704 Discussions

Can't program the flash device

Altera_Forum
Honored Contributor II
‎08-02-2010 03:13 PM
1,220 Views

I have just received the Cyclone III development kit and I'm trying to figure out the flash programming. I have a .pof file that I wish to replace the default factory .pof file. I have followed all the steps from the guide and then I get to step 11: turn on Page_0 and Option_bits in the Program/Configure column. However, nothing happens when I click on it. No check mark appears. What am I doing wrong? 

 

Another difference from the example picture is their checksum says 00000000 while mine says C5E01BF4.
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎08-02-2010 05:22 PM
264 Views

I figured it out. Apparently you need to have a top design file in the file field for the top device. This doesn't follow what their guide says but it worked for me.

0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.