- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I am new to CPLDs and would like to know how they can be programmed(which software, cables etc), their cost. Do I need to buy a development kit to program a CPLD? I am currently using UP3 Education Board. Can I use that to program a CPLD? Thanks for the replies, AmjadLink Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
As far as I know, CPLDs are programmed via jtag port. They do not have dedicated configuration ports as FPGAs.
So to program it, put it on jtag chain of your board if it can be interfaced. They retain their config at power down but have limited erase/program cycles.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for the reply. I will try your suggestion...
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page