- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hey,
I am using EPF10K100EQC240-3 IC with 8MHz crystal (SG-615P). When I measure signal on the crystal I see only 60Hz (in my country the frequency of AC power is 50Hz) instead of 8MHz. The board is working well. Can some explain me please how is it possible? Thanks aheadLink Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
How did you measure your clock signal? Did you use a scope? What does the waveform look like? Are you sure you have a good ground connection?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I already understood where was my mistake.
I used digital scope and the sampling frequency was too low.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page