- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have a Cyclone III Development Kit but I have not been able to program it. Nothing shows up in the JTAG chain.
The LEDs are flashing back and forth. I've tried setting the switches per the documentation and trying out different combinations but still haven't been able to get any devices to show up in the JTAG chain. Can anyone confirm what switch settings they use when programming the board? I got the error: "Error: Can't access JTAG chain Error: Operation failed" in Quartus 9. Upgraded to 11 and still can't program. In Quartus II v 11 I'm getting the error: Error: Device chain in use Error: Operation failedLink Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ......
i have a cyclone 3 dev board working here......... the board had a SW1 ( 8 dip switchs) all dip switchs to down only 5 dip switch to up ( dip sw 5 to open) and sw3 fpga bypass to up (1) and others to down (0) you need to install the driver to usb blaster ......... it is on quartus directory /drivers/usb-blaster thats it Franz Wagner- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Finally got it to work by uninstalling and reinstalling my USB blaster driver to the version that came with version 11.
Thanks for the response.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
sounds good lol
:D
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page