- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi everyone, do you know how to store file from RS232 to SDRAM/SRAM/Flash?
Thank you very much.Link Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This is for SRAM:
1. the RS232 should pass 1'st the RS232 to LVTTL or LVCMOS by hardware 2. then, in FPGA you may instantiate UART (with the right settings and BOUD rate). 3. Then, when you get the octets, each octet should be written into SRAM (produce WR pulse) and address counter. should be incremented to next sample location.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank for your ans... can i have any reference of it? I am a beginner of it.. Thank you very much ..
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The lrvrl converter may be the following:
http://focus.ti.com/lit/ds/symlink/trsf3221e.pdf for UART.... you should write it or get something like this: http://soursecodes.blogspot.com/ You need only the RX part and the modules which serve it... For writing into SRAM look at the DPR specification. It is usually like this: CLK: ____________|-------------- _________ xxxxxxxxxx WR DATA xxxxxxxxxxx ------------- _________ xxxxxxxxxxx WR ADDR xxxxxxxxxxx ------------- WR_EN ____|-----------|__________
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page