- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi:
I build the sof file without problem. somehow, when I program it to the board, the progress bar stops at 80%. It is cyclone iii 3c25f324 fpga. Is it related to any specific issue? ThanksLink Copied
4 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Any error msgs?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
no, I tried programming with the sof file built under 9.1 months ago and it is good. I updated to 10.0sp1. I noticed the LE 100% occupied. could it be a problem?
Total combinational functions 21,403 / 24,624 ( 87 % ) Dedicated logic registers 15,775 / 24,624 ( 64 % ) Family Cyclone III Device EP3C25F324I7 Timing Models Final Total logic elements 24,565 / 24,624 ( 100 % ) Total registers 15933 Total pins 128 / 216 ( 59 % ) Total virtual pins 0 Total memory bits 151,221 / 608,256 ( 25 % ) Embedded Multiplier 9-bit elements 53 / 132 ( 40 % ) Total PLLs 1 / 4 ( 25 % ) --- Quote Start --- Any error msgs? --- Quote End ---- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
There were some problems with the 10.0 programmer, I think I had to use an earlier version with a Cyclone II. They seem to have been fixed with 11.0.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What windows are you using? And what version of Q(32/64bits)?
Try using command line, go to nios 2 command shell, cd to your directory and do a nios2-configure-sof /your/sof/path
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page