- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I am looking at migrating a design from a Max II to Max V device. Looking at the data sheets they look very similar which suggests it was essentially a die shrink. But I would like to be sure! Is there any documentation about this or has anyone else been down this road? Thanks MarkLink Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
they seem awfully similar, but i don't think you'll find any official documentation on the changes
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page