- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
We are using Arria 10 EMIF. We need to control the memory components’ mode register settings through Controller Register Writes. Please let us know the sequence of Controller register write to initiate write to Memory components’ mode register (MRS0-MRS6). Thanks & Regards S.T.SaraswathyLink Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
This gets configured in the EMIF controller parameter editor when you add the controller through the IP catalog or in Qsys. It's handled automatically by the controller during memory initialization. See this online training:
https://www.altera.com/support/training/course/omem1122.html- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi
Thanks sstrell. The section 3.4.1 of "JEDEC DDR4 SDRAM Specification" says that "Mode Registers can be altered by re-executing the MRS command during normal operation." In case if I want to do the same in my simulation (i.e rewrite to MR register after initialization), how can I achieve it in Arria 10 EMIF Simulation Setup Thanks & Regards S.T.Saraswathy
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page