Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
16558 Discussions

difference between line command in .do and display in modelsim

Altera_Forum
Honored Contributor II
939 Views

Hi,  

 

in my file .do to create and launch simulation when i modify my signal with command line "wave modify -driver freeze -pattern clock -initialvalue 0 -period 25ns -dutycycle 50 -starttime 0ns -endtime 1000ns NewSig:/sigmed_top/clk_ext"  

there is factor 100 and i get a signal with period of 250ps and endtime 10ns  

 

If i "modify" signal without changing parameters and valid, it's ok but i don't find a command line to resolve my probleme. I think the problem comes in Simulate/runtime option ( parameter: "default run")  

 

thank you for your answers 

 

PS: i use modelsim starter edition 10.1b
0 Kudos
0 Replies
Reply