- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I am searching a way to read/write data from/to the configuration flash (EPCS16) without using NIOS. Is it necessary to use the "EPCS serial flash controller core"? Is there another way to access the configuration flash? If there is another way, where can I find it (I have not found it so far)? Thank you in advance. SteveLink Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm not sure about this, but if you set the EPCS pins as I/O after configuration you could implement some kind of SPI controller to access it.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page