- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have one thing to check out. I am recently use Altasmi_parallel & altremote_update for my Cyclone IV E for remote update. and use EPCS64, i have finish two project, one for Factory mode and the other is Application mode, and then combine the two .sof into a .pof file and then program into the EPCS64, and now i want to update the application file remote, i will erase the exist application in the EPCS64 and then write the new file. and my question is: what file do i need to send down? is it new .sof? or other file? Does the EPCS remote update support other file? take a example.thanks! stephuaLink Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It sounds like you are trying to store two FPGA images in a single EPCS64. In which case you need to store the .sof file at each boot address.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Do you implement the Remote Update? I meet the same problem, can you share the experience? Thanks!
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page