- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In the document "Cyclone V device schematic review worksheet" It is written that JTAG header VCC pin should be connected to VCCIO3A
In the handbook of Cyclone V it is said that JTAG header Vcc pin should be connected to VCCPD of 3A bank. Since VCCIO3A voltage level is 1.8V and VCCPD is 2.5V in this condition, I coud not decide to connect any of the supplies. Which document is incorrect? Thanks for your answers.Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
VCCPD
Refer to Figure 7-17 (page 7-26) in the Cyclone V - "Configuration, Design Security, and Remote System Upgrades in Cyclone V Devices" document. http://www.altera.com/literature/hb/cyclone-v/cv_52007.pdf (http://www.altera.com/literature/hb/cyclone-v/cv_52007.pdf) Cheers, Alex
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page