Intel® Quartus® Prime Software
Intel® Quartus® Prime Design Software, Design Entry, Synthesis, Simulation, Verification, Timing Analysis, System Design (Platform Designer, formerly Qsys)
16599 Discussions

Pin Assignements Wont Display in BDF Schematic File after compilation

Altera_Forum
Honored Contributor II
‎09-01-2016 01:21 PM
1,061 Views

Please Help.. 

 

For the life of me I cannot get I/O pin assignments to appear on my BDF file. 

 

I realize the question is vague, but I am stuck.  

 

Using QUARTUS II Software with MAX II 1270T144 device. 

 

I believe I assigned all the pins properly, as the FIT report shows success and the  

locations are correct. However NOT SHOWN in my schematic/bdf. 

 

Thanks. 

BS
0 Kudos

Link Copied

1 Reply
Altera_Forum
Honored Contributor II
‎09-08-2016 09:41 AM
273 Views

okay. pretty please.... 

 

There has gotta be a genius out there that can help with this pathetic little nuisance problem. 

 

Bob
0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.