- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Greetings everyone
I have created a project using block diagram schematic in quartus ii software. The project is a simple multiplexing system. I have downloaded the project into the target FPGA on Altera DE2 board. The project runs without problem and the LEDs show the blinking correctly. But I just can't Simulate the project using Quartus II waveform editor. So, what is the reason for that???? I mean if the project runs correctly that means there is no problem, so why not giving output in Simulation??? Thanks!Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Have your created a test bench to drive the inputs?
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page