- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Is it possible not connect power the VCCIO voltage on unused banks in Arria 10 devices (for example, leave unconnected)?Link Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Yes, you can power down the VCCIO voltage of unused I/O banks except I/O Bank 2A in Intel® Arria® 10 devices. I/O Bank 2A is not allowed to be powered down because the I/O Bank is monitored by the Power-On Reset (POR) circuitry. https://www.altera.com/support/support-resources/knowledge-base/component/2018/it-is-possible-to-power-down-vccio-voltage-on-unused-banks-in-ar.html Best Regards, Anand Raj Shankar (This message was posted on behalf of Intel Corporation)- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
explain, please, that means "power down": 1. I can switch off VCCIO voltage of unused I/O banks after the power-on all FPGA VCCIO voltage? or: 2. I can not connect VCCIO voltage of unused I/O banks on the pcb board and leave VCCIO pins of unused I/O banks float?- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
HI,
Both options can be considered, But option one is the better choice considering the feasibility of modification if required. Best Regards, Anand Raj Shankar (This message was posted on behalf of Intel Corporation)
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page