Embedded Intel Atom® Processors
Technological Conversations about Intel Atom® Hardware, Software, Firmware, Graphics

Atom E6xx CLK-DQS skew

idata
Employee
1,385 Views

cb Hello,

We are busy with the pcb layout for a Atom E6xx with 8 loads memory.

I am now confused about the length matching between the clock (CLK) and stobe (DQS) lines.

In the datasheet 433311_Rev3.0.pdf on page 36 is mentioned:

The total length of DQS of each byte group must be greater than or equal to CLK + 0.15 in., and must be less than or equal to CLK + 0.5 in.

If I then look at the guideline 325550.pdf (Intel® Atom™ processor E6xx Series – Memory Design Optimization for Small Form Factor), I see on page 23:

The total length of DQS of each byte group must be greater than or equal to CLK - 0.3 in., and must be less than or equal to CLK + 0.2 in.

What should I use for the length of the DQS line matching to the CLK?

Thanks!

 

0 Kudos
1 Reply
FMcNu1
Valued Contributor I
493 Views

Hello

I want to make you aware of a special place to go with questions like yours. The Intel® e-Help desk is staffed by Intel representatives who support select Intel embedded platforms including Intel® Atom™ and associated chipsets.

To access e-Help, you need to be a Privileged member of the Intel® Embedded Community.

If you are not already a Privileged member, you can request an upgrade to your community account here:

https://edc.intel.com/My-Account.aspx https://edc.intel.com/My-Account.aspx

In addition to access to e-Help, Privileged members may also access the confidential content within the Intel® Embedded Design Center, such as design documents, specifications, and training materials.

I hope this helps.

Felix

J. Felix McNulty

Community Moderator (Intel contractor)

0 Kudos
Reply