- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Openni2 is installed on the Euclid by default. After starting the Cameras scenario, I try launching it with `roslaunch openni2_launch openni2.launch` and it prints the following error:
"No matching device found... waiting for devices. [...] Invalid device number 1, there are 0 devices connected."
Does the launch file need to be edited? The camera nodes are running and publishing valid data, as seen on rviz.
1 Solution
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Sbierwagen,
Thanks for your patience. After some research I would like to let you know that OpenNi does not support RealSense cameras.
Regards,
-Yermi A.
Link Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Sbierwagen,
Thanks for your interest in the Intel Euclid Development Kit.
We would like to investigate a little bit more and as soon as we have useful information we'll let you know.
We'll appreciate your patience during the meantime.
Regards,
-Yermi A.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Sbierwagen,
Thanks for your patience. After some research I would like to let you know that OpenNi does not support RealSense cameras.
Regards,
-Yermi A.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page