- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello all,
Are the specific dimensions of the R200 model available? Specifically I would like to know the distances from one end of the module to the center of each of the 3 cameras. I am building a mount for the realsense that sort of clamps it in the middle, and I wanted to be sure the clamps don't obstruct any of the cameras' FOV's.
Thank you!
Thomas
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The front glass obscures the innards, so it's hard to tell the distance between the cameras. If you use the internal drawing below as a guide though, you can see there's quite a distance between the cams in the middle, so it should not be too hard to estimate where to put a mount without obscuring a camera.
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The front glass obscures the innards, so it's hard to tell the distance between the cameras. If you use the internal drawing below as a guide though, you can see there's quite a distance between the cams in the middle, so it should not be too hard to estimate where to put a mount without obscuring a camera.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page