- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am trying to connect USB Blaster to Cyclone 10 LP eval kit directly. Is it possible? i cannot connect to the EPCQ device.
Link Copied
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi AZeli,
we can connect USB blaster to Cyclone 10 LP eval kit but.
- USB Blaster Programming J2 Header uses JTAG mode only.
- To connect it to EPCQ we need to use build in USB blaster using USB connector J17.
Let me know if this has helped resolve the issue you are facing or if you need any further assistance.
Best Regards,
Anand
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you for the response.
I connected a USB blaster to J2 and scanned the chain. I see two devices - the FPGA and a virtual device. I didn't see the CPLD on the chain, which led me to suspect that there is a separate JTAG chain for it. I think I also figured out the EPCQ already.
Is there a way to eliminate the virtual device from the chain?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi AZeli,
Yes, can eliminate the virtual device from the chain using DIP switch SW1.
SW1.4 Logic 0 = Vitual JTAG Bypass
Logic 1 = Vitual JTAG Enable
Regards
Anand
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page