FPGA, SoC, And CPLD Boards And Kits
FPGA Evaluation and Development Kits
5933 Discussions

Part#EK-10M08E144 power connection

DDUNN
Novice
‎07-02-2019 12:29 AM
673 Views

When the customer connect USB cable to EK-10M08E144, red LEDs turned on continuously. Per datasheet, When powered correctly, a pre-programmed design blinks LEDs D1 through D5 ON half a second then OFF half a second. Is this product out of order? or how should the customer proceed? please help to advise. Thank you. Dan.lee@mouser.com

EK-10M08E144.PNG

0 Kudos

Link Copied

1 Reply
AnandRaj_S_Intel
Employee
‎07-02-2019 02:46 AM
483 Views

Hi Dunn,

 

Board is pre-programmed with different design.

 

MAX 10 FPGA (10M0S, 144-EQFP) Evaluaion Kit User Guide is not been updated,The pre-programmed design is connection between SW3 (1 - 5) and led (D1 - D5).

You can change SW3 state to see the difference.

Sorry for the inconveniences caused.

 

Regards

Anand

 

 

0 Kudos
Copy link
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.