Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20645 Discussions

I have a problem with program. when i download a sof file with jtag,it successd in case of msel value 001(ps/fpp mode).But if msel set to 011(as mode),it fail,error ID:209014.

SHuai
Beginner
718 Views

The chip is 10AS016E3F27.

In ps/fpp mode,jtag detect 2 device,10AS016E3 and SOPVHPS

In as mode,jtag detect 1 device,10AS016E3

I have connect nCONFIG,nSTATUS,CONF_DONE through a 10 k resistor to VCCPGM,nCE to GND.

How should i solve the problem.

Thank you!

0 Kudos
5 Replies
ShafiqY_Intel
Employee
442 Views

Hi SHuai,

 

The reason of this error is the CONF_DONE pin in the device did not go high at the end of configuration.

Here are some factors of this error:

  • Communications cables not securely connected
  • Incorrect device selected
  • No power to target system
  • Device nCE pin not connected to GND

 

Here some workaround you can try:

  • Remove the SD card and reinsert it in the bard farm machines
  • Can you kindly try to reduce your TCK frequency to 6 MHz (default value)?

Below link is the command to change TCK frequency (on page 14= 2.8. Changing the TCK Frequency) https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/ug/ug_usb_blstr_ii_cable.pdf#page=14

 

I hope this will help.

 

Thanks

 

0 Kudos
SHuai
Beginner
442 Views

I had reduce TCK frequency to 6 MHz but the problems remain​.

Thanks​

0 Kudos
ShafiqY_Intel
Employee
442 Views

Hi SHuai,

 

May I know the status of this issue?

 

Thanks

0 Kudos
SHuai
Beginner
442 Views

The problem has been solved.

The hardware engineer made a mistake that there are differences between boards and schematic design.

when I set msel value 011,actual setting is 101.It is a wrong configuration.

Thanks​

0 Kudos
ShafiqY_Intel
Employee
442 Views

Hi SHuai,

 

I am glad to hear that the issue is resolved.

I will close this thread. If you have further question, please submit a new forum thread.

Thanks

0 Kudos
Reply