- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi.
Just recently acquired the dev kit, and the question might sound a bit silly, but im wrestling google and the altera site to find out to which header I should plug the LCD graphic display power connecter (and in which orientation). The manual and the reference documents that came with the kit dont say much about that, although it looks in the picture as if it should be connected to the j6 connector (which is a 2-pin header: GND and -12v), but I went on to see the LCD datasheet just to make sure and surprisingly found out that the maximum absolute voltage is 7v. Can anyone lend a hand here ? ;)Link Copied
1 Reply
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Connector J6
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page