- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, I am using the Cyclone V SoC (5SCEMA5F31C6N) and I want to set up a simple Partial Reconfiguration Project.
I'm getting an error when trying to configure an internal host using the megawizard function saying that this feature is not supported by my device. In the Cylone V Device Oveview, its mentioned that "Partial reconfiguration is supported through the FPP x16 configuration interface". Does this mean that Cyclone V only supports PR with external hosts? Kind Regards JohannesLink Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
PR is supported with internal and external host as explain from the user guide.
https://www.altera.com/content/dam/altera-www/global/en_us/pdfs/literature/megafunctions/ug-partrecon.pdf Make sure you are using the lastest Quartus II version that support this IP with Cyclone V.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
--- Quote Start --- PR is supported with internal and external host as explain from the user guide. https://www.altera.com/content/dam/altera-www/global/en_us/pdfs/literature/megafunctions/ug-partrecon.pdf Make sure you are using the lastest Quartus II version that support this IP with Cyclone V. --- Quote End --- The user guide refers to the Stratix V device family (see first paragraph). I am using a Cyclone V board which has a reduced feature set compared to Stratix. Is it still possible to use an internal host?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
johker,
are you using the Terasic DE1-SoC Board with the Cyclone V SoC 5CSEMA5F31C6 device?
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page