- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i write a project after compile, it success, then start processing but stop at 2% what is wrong with this? when i run it, it just continue consume cpu memory
Link Copied
3 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
For how long did you let it run? You could have a project that generates a lot of logic (sometimes not on purpose, with big loops or recursion).
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Later tell you, i have not finished mac control interface's address part.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
--- Quote Start --- You could have a project that generates a lot of logic (sometimes not on purpose, with big loops or recursion) --- Quote End --- Might be a good guess. Code snippets previously shown on the forum had non-synthesizable while loops.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page