- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi All!
I'm in the beginning phases of designing a board around the Cyclone V HPS and I can't find the power requirements for the on-chip A9. I've used the early power estimator for the FPGA side. Any answers or pointers would be greatly appreciated. Thanks!Link Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can use the power play tool if you compile for a Cyclone V HPS. I don't think the numbers are very accurate though.
You can twiddle the switching rate of the processor in power play and it doesn't look like the dynamic power scales correctly.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
--- Quote Start --- You can use the power play tool if you compile for a Cyclone V HPS. I don't think the numbers are very accurate though. You can twiddle the switching rate of the processor in power play and it doesn't look like the dynamic power scales correctly. --- Quote End --- By that you mean the early power estimator, right? There are no fields for the processor in that tool as far as I can see (only LUT %, IO, XCVR, etc). Are there in the version that you use?
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page