- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
an information in the cyclone III handbook section 3 (page 10-66) says that pin DATA[1], ASDO are not available in user mode if I use AP configuration mode. But there is also the information: "After AP configuration, DATA[1] is a dedicated bidirectional pin with optional user control." Is it possible to control this pin in user mode with an AP configuration mode ? The same problem exist with DATA[7..2] and DATA[15..8]. Can I also control the PADD[23..0] in user mode to use the flash ? Thanks.Link Copied
0 Replies
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page