- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I've started working with the Stratix IV devkit and noticed that programming procedures require that a second PC program the board plugged into a first PC. In other words it does not appear to support hotplug or re-enumeration. Does anyone know a way around this, or where the problem lies? Is this an issue with the PCIe hard block on the Stratix IV or with the Jungo drivers or the OS ... or ... ? Any advice is greatly appreciated. Thanks, PeterLink Copied
2 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
i do not know the technicals of why this doesn't work, but you can get away with 1 PC if you boot the PC, program the FPGA, and hit the PC's reset button. the FPGA will not lose its configuration when the PC resets.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Not reset. Ctrl+alt+del.
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page