Programmable Devices
CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers
20707 Discussions

start address of the application configuration in remote configuration mode

Altera_Forum
Honored Contributor II
‎12-23-2011 12:41 PM
853 Views

Hi, 

 

I have a CyIV GX connected in active serial with an EPCS128. 

I would like to use the IP altremote update for managing a "factory" and an "application" area in the EPCS. 

Because i'm in AS configuration (no pgm pins) i need to use the altasmi parallel IP. 

 

"after power up or a configuration error, the factory configuration logic writes the 

remote system upgrade control register to specify the address of the application 

configuration to be loaded." 

 

How the CyIV knows the value of the start address of the application 1 configuration ? 

Because this action is automatic, so it doesn't depend on the user logic implemented in the design.
0 Kudos

Link Copied

0 Replies
Reply

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.