How do you Upload Seperate files onto Flash/epcs

Programmable Devices

CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers

How do you Upload Seperate files onto Flash/epcs

896 Views

Hello All,

I am attempting to now learn how to carry out a boot seq for my device..

I need to too be able to store some calibration and factory setting file in the EPCS flash, and on boot up i need to load those files on to sram.

I have figured out how to read and write to the EPCS from nios, but kinda stuck in how would you now take a simple Calibration files, which contains pixels data 16bit each, from my pc and dump it on the EPCS flash using the Flash programmer.

Can this be done, is Flash programmer the tool i need to use?

What format should the file be?

thank you

regards nadeem

Link Copied

0 Replies

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.