FLASH CFI table Reading problem

Programmable Devices

CPLDs, FPGAs, SoC FPGAs, Configuration, and Transceivers

FLASH CFI table Reading problem

944 Views

hii,

my design contains nios2 prosessor i have used generic tristate controller with tristate cudit bridge to interface with flash.

my desigh system clock is 50 Mhz. i am trying to read CFI table through NIOS2 console window. I can able to read CFI table after power on reset only, but if i read again then in nios2 console window its showing NO CFI table found. but after evet board reset if i read CFI table its coming. but it should come contiuously without board reset.

Flash Device : Micron M29w128GH70Z86E

timing parameters which i am using while configuring "generic tristate controller" : setup time : 75 ns, hold time : 0ns, Read wait time : 200ns, write wait time 200 ns;

thanks

Link Copied

0 Replies

Community support is provided during standard business hours (Monday to Friday 7AM - 5PM PST). Other contact methods are available here.

Intel does not verify all solutions, including but not limited to any file transfers that may appear in this community. Accordingly, Intel disclaims all express and implied warranties, including without limitation, the implied warranties of merchantability, fitness for a particular purpose, and non-infringement, as well as any warranty arising from course of performance, course of dealing, or usage in trade.

For more complete information about compiler optimizations, see our Optimization Notice.