- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
When I complied my project yesterday, QuartusII software gave me a error message:
Error: Can't place 108 pins with 2.5 V I/O standard because Fitter has only 81 such free pins available for general purpose I/O placement. I know there are more pins in my projects than the device could provided, but I seemed to once seen that QuartusII could assign some virutal pins, I did not know how to made these assignments in QuartusII. I used CycloneIII device and QuartusII8.1. Could anyone tell me where I can made the assignemts in QuartusII for the virtual pins, or the blurry memories that I remembered was wrong? Any suggestion is greatly appreciated!Link Copied
4 Replies
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
--- Quote Start --- When I complied my project yesterday, QuartusII software gave me a error message: Error: Can't place 108 pins with 2.5 V I/O standard because Fitter has only 81 such free pins available for general purpose I/O placement. I know there are more pins in my projects than the device could provided, but I seemed to once seen that QuartusII could assign some virutal pins, I did not know how to made these assignments in QuartusII. I used CycloneIII device and QuartusII8.1. Could anyone tell me where I can made the assignemts in QuartusII for the virtual pins, or the blurry memories that I remembered was wrong? Any suggestion is greatly appreciated! --- Quote End --- You can do that on the Quartus Assignments Editor by making unused pins as Virtual
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
To vijays,
Thank you very much for you help, I have find Virtual pins assignments in Quartus Assignment Editor.- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Everbody,
I am trying to communicate between the cyclone 2 EP2C5Q208C8N and the SDRAM, (Model: IS45S16400F , 1 Meg Bits x 16 Bits x 4 Banks (64-MBIT),SYNCHRONOUS DYNAMIC RAM). (I use Quartus 8.1) But to understand how it works I tried the Tutorial, but in this tutorial they use the NIOS 2 Processor, so I need to understand this processor. So I began the tutorial “My first NIOS 2 processor Getting started”. Problem: The examples are only for the cyclone 3 or other fpga`s. So I chose another tutorial: “Nios 2 Development Kit Getting started” Problem: I have the same problem like senlin. But I don`t know which signals/pins I have to change in the assignment editor that the software don’t give me the error message again. Somebody can help me, please?- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Use a latest version of Quartus, 12.1SP1 web edition
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page